Skip to main content
All CollectionsUsing EargoUSING EARGO
Inserting & Removing Eargo 5, 6, & 7 Devices in the Charger
Inserting & Removing Eargo 5, 6, & 7 Devices in the Charger

Eargo 5, 6, & 7: How do I insert Eargo in my Charger properly?

A
Written by Admin
Updated over a week ago

To insert your Eargo devices into the charger, flip your device over so that the Device Removal Thread is pointing upwards. Position it over the Charger with the Petal pointing in.

Release the device and it will settle into place inside the cradle:

Make sure that the Device Removal Threads are centered inside the Lid when you close the Charger:

If you continue to see the “Insert or reinsert your Eargo devices…” screen in the mobile app, additional cleaning may be warranted before you can continue.

First, remove the devices from the charger. Use the Cleaning Tool Wiper to remove wax and debris from the Sensor and Hearing Device Cradles.

These areas must be clear of any debris for your Eargo devices to communicate with your charger:

Finish removing wax and debris from the Sensor with the Cleaning Tool Brush:

Wipe the Hearing Device Cradles with the Cleaning Cloth:

Next, brush the petal to remove wax and debris from the tip to the holes. The Petal must be clear of debris for your Eargo devices to communicate with your charger.

Wipe the devices with the cleaning cloth:

Next, hold the device firmly around its middle. With your other hand, grasp both layers of the Petal and peel it away to expose the sound outlet. Gently use the Cleaning Tool Brush to dislodge any debris that may have been hiding under your Petal. The sound outlet must also be clear of debris for your Eargo devices to communicate with your charger.

When ready, place your Eargo devices back into your charger as instructed above and select Continue in the mobile app. If you’re able to proceed, debris was the root cause of the problem. You may reassemble your devices at your convenience. To do so, align the Sound Outlet on your Eargo device with the center of the Petal. Press into place until you feel a click.

If the “Insert or Reinsert your Eargo devices…” screen returns in the mobile app in the short term, consider replacing your Petal with a new one. Persistent debris in your Petal may continue to be blocking communication between your Hearing Device and the charger.

To read more about insertion techniques click here. To read about additional cleaning and care click here.


Did this answer your question?